on 05-28-2006 3:16 PM
Hi,
i put two receive step in fork step and two send step.
two receive step has start point, when both two step are received, one receive step will be sent to legacy and then another receive step wil be sent to legacy. if one of receive step is not received, send step should not be activated.
my problem, when two receive step were received, send step does not work, in sxmb_moni, i can see this "message is being sent".
what did i have wrong step?
thanks
venjamin
Venjamini,
Goto SXMB_MONI and double click on message to check Workflow status.
From workflow status you can make out the error / weather it still waiting for input. I had same problem where workflow was in incomplete status and went into indefinate loop..was expecting some more input.
Hope this will help you.
Cheers,
Nilesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Hope you have proper correlation set up in the BPM.
Go to Technical Details of the BPM to get the more info.
( SXMB_MONI->PE->Technical Details)
just cross check with BPMPatterns in the SAP BASIS software component.
http://help.sap.com/saphelp_nw2004s/helpdata/en/cb/15163ff8519a06e10000000a114084/content.htm
http://help.sap.com/saphelp_nw2004s/helpdata/en/0e/56373f7853494fe10000000a114084/content.htm
>>>just go to SWWL transaction and delete all the error workitems and process once again..
Hope this helps,
Regards,
Moorthy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.