on 11-20-2009 8:10 AM
hi
When I goto T.code rsa1 following error shows:
"Error during internal number assigment for port names"
for detail it shows
"Message number E0551
An internal number could not be assigned for the number '01' for the number range object EDIPORT"
What is the solution??
Hello,
Well, i know it's too late to help you, but since i ran into the same problem, i will tell the answer to this one
The error is occurs when, during the creation of the source system, it's impossible to generate automaticly a transactional rfc port name in tx WE21
So the first check you need to make is to try creating such a port in tx WE21 either on you BW system and your ECC system.
In my case, the automatic generation of port name failed in my ECC system.
So i went in tx SNUM and checked if the object EDIPORT was created.
Then, i clicked on the "number range" button and i checked the intervals (nothing was here, so it's the root cause of the problem)
I created the intervals, and started again the creation of the ECC source system in my BW.
This time the system was created succesfully!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
I just create a logical system and assign it to my client and save it.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Have you checked note 110849 ?
Looks similar to the error.
Best Regards
Raghu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi iskhan,
Recently you did any configuration. i mean u created any connection through BW system. if it's so than you have to check with your confuguration or delete and try again.
I hope this will help you.
With Regards,
CSK
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
98 | |
11 | |
11 | |
10 | |
10 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.