on 05-26-2006 6:38 AM
I have configured two r/3 systems for to transfer idoc.
the idoc is generated successfully but it is not transferred to the destination port.
The idoc status is 30 :IDoc ready for dispatch (ALE service) .
ideally it should come as 03:Data passed to port OK
Am I missing some configuration ? Kinldy advise.
Thanks
Ravish
Hi Ravish,
Please goto <b>SM58</b> and check if the IDocs are stucked up on the t-rfc queue. If so, you can right click and choose Execute LUW to release them.
For other solution, you can use program <b>RSEOUT00</b> to pass the IDocs to the port.
Again, hope this will help.
Regards,
Ferry Lianto
Please reward points if helpful.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I had the same problem, what a very obscure cause for the problem!!!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ravish,
Glad the problem was solved.
Please check this online document for ALE and IDoc.
http://help.sap.com/printdocu/core/Print46c/en/data/pdf/BCMIDALEIO/BCMIDALEIO.pdf
http://help.sap.com/printdocu/core/Print46c/en/data/pdf/BCMIDALEPRO/BCMIDALEPRO.pdf
http://help.sap.com/printdocu/core/Print46c/en/data/pdf/CABFAALEQS/CABFAALEQS.pdf
http://help.sap.com/printdocu/core/Print46c/en/data/pdf/BCSRVEDISC/CAEDISCAP_STC.pdf
http://help.sap.com/printdocu/core/Print46c/en/data/pdf/BCSRVEDI/CAEDI.pdf
Also check this links for additional information.
http://help.sap.com/saphelp_erp2004/helpdata/en/dc/6b835943d711d1893e0000e8323c4f/content.htm
http://www.sapgenie.com/sapgenie/docs/ale_scenario_development_procedure.doc
http://edocs.bea.com/elink/adapter/r3/userhtm/ale.htm#1008419
http://www.netweaverguru.com/EDI/HTML/IDocBook.htm
http://www.sapgenie.com/sapedi/index.htm
Regards,
Ferry Lianto
Please reward points if helpful.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ravish,
Please check the partner profile (<b>t/code WE20</b>).
Perhaps the output mode was setup to trigger by background job instead of immediately.
Regards,
Ferry Lianto
Please reward points if helpful.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ferry Lianto,
The outbound mode is set to Transfer IDOC immediately, and inbound parameter is also set to Trigger immediately, but the problem still persists. And the current status is still 30. if its transferred and recieved at the receiver port, then the status should be set to 03. Which doesnot happen. Please advise
User | Count |
---|---|
82 | |
10 | |
10 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.