on 11-15-2009 12:39 PM
Hie Guru
I have been able to configure a network printer that is connected to a PC using Access method S and installing SAPSPRINT on the printserver. I'm now faced with a challenge on configuring a stand alone network printer. I would like to kno w that since this Ptinter is not connected to any PC were do i install SAPSPRINT. I'm also not very sure if the entries i made in Tcode SPAD are correct.
Access Method: U
Host printer: <name of printer>
Destination Host: <IP Address of the Network Printer>
Please any suggestions are welcome!
Regards
Hi
It's realy tough to list all steps require to configure printer. So please go through below links and follow the instructions.
Please note, it's only informative references thus you require to take the right dicesion.
http://help.sap.com/saphelp_nw70/helpdata/en/d9/4a956151ea11d189570000e829fbbd/frameset.htm
http://www.oit.state.pa.us/ob_imaginepa/lib/ob_imaginepa/sap_support/sapprintguide.doc#Ai
Regards
Sekhar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.