Message Interface do not show the Message Type

[Former Member]

Hi All,

I have imported project.DTD file in External definations. Project.DTD file inturn references few other dtds. So i have imported all dependent dtd's in External definations.

When i click on Message Interface, try to choose Message type for Project, i do not see Message types.

Kindly help.

Thanks & Regards,

Gowri

[Former Member · Accepted solution]

Hi Gowri,

what have you chosen as category for your External Definition?

What did you choose in the field 'Messages'?

What do you see when you change to the WSDL-tab?

Greetings

Stephan

[Former Member · Accepted solution]

Hi,

When i open the DTD in XML editor, it shows some error. This could be the problem.

Thanks Moorthy and Stephen for your help.

Warm Regards,

Gowri

[moorthy]

Hi Gowri,

Did you activate the External Definition after importing the dtds.. otehrwiese activate it

Also check that these dtds are imported correctly by clicking on Messages tab in the External Definition

Then go to Message Interface and look for External Definition and select specific one

Thanks,

Moorthy

[Former Member]

Hi Moorthy,

I have activated dtds in External defination. When i click on message tab in External defination for DTDs, it is blank...

Thanks,

Gowri

[moorthy]

Gowri,

Probably your DTD is incorrect. check with any xml Editors , validate it and try to reimport the same. If you don't have proper message structure you cannot see the messages in teh Message Interface..

Thanks,

Moorthy