on 11-10-2009 6:01 AM
Dear all,
what are all important things should be assigned for inspection plan QP01
let me know in detail
Regards
kumar
Hi
important things should be assigned for inspection plan QP01
At header level:
Dynamic mofication rule
Inspection point
sample drawing procedure.
at operation level:
work center
operation key
additional operation
at char level:
DMR
MIC
Inspection method
sampling procedure
PRT
etc
I hope this will add some value
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear,
QP01 is same like the routing creation through CA01.
In QP01 , enter Material , Plant , Key Date , press enter.
Then create Inspection Plan as per your requirement.
Please refer this wikki,
https://wiki.sdn.sap.com/wiki/display/Snippets/ABAPProgramtouploadQMInspectionPlanUsingBAPI
Regards,
R.Brahmankar
Edited by: R Brahmankar on Nov 10, 2009 12:16 PM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
We define following Master Data's independent to each other:
1. Material Master
2. Master Inspection Characteristics
3. Inspection Methods
4. Sampling Procedures
5. PRT's
In Inspection Plan we define to the system that for one particular material what are all the parameters (MICs) to be tested using specific procedures (Inspection Methods and Sampling Procedures) and Instruments (PRT's), which have defined earlier.
Hope this is clear to you.
Best Regards,
K. Raghavendra Nayak
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
103 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.