on 11-03-2009 12:11 PM
Experts,
When I create a MIC with reference to a class characteristic, I can not maintain the control indicator flags "lower spefic. limit" and "upper specific. limit". I can also not find these in any table (only in a structure).
But to use the note 119708 this is required.
Is there any way I can maintain this in the class characteristic? or how else can I overcome this problem?
Thanks!
Dear Jan
if you are maintaining MIC with class characteristic in MIC lower and upper will automaticaly get seleted
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
When defining Class Characteristics please maintain range for the values Tab ex. 1-10 then automatically when you define MIC with reference to this Class Characteirtic Lower and Upper Limits are marked and would be same as that maintained in Class Characteristic which cannot be edited in MIC.
Best Regards,
K. Raghavendra Nayak
Dear Jan
Hope you have chosed Data Type as NUM
In that tick the intervals val allowed and in values you can maintain interval as 30 - 40 ( if the lower was 30 and upper was 40 )
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.