cancel
Showing results for 
Search instead for 
Did you mean: 

TO item split needed

Former Member
0 Kudos

Folks,

I have the following requirement:

  • Material is subject to alternative UOM: 5 PCE = 1 PAK

  • Orders can be in both PCE and PAK

  • Because of that, ATP situation can result in partial PAK's.

  • Delivery for 14,8 PAK

Requirement:

TO with 1 item with 14 PAK and 1 item with 4 PCE.

I've tried MWMTO012 and MWMTO012 but both without results...Any other suggestions?

Thanks,

MZ

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi,

I don't think we can change UOM during TO creation. TO is always in WM/Alternate UOM. You better set up PAK as Storage Unit type instead of UOM. And always create Delivery with Base UOM or Alternate UOM. This way you can split TO items based on Full pallet and partial pallet quantities and is pretty standard in WM.

Thanks

Vinod.

Answers (2)

Answers (2)

Former Member
0 Kudos

used an enhancement in TO save which checks on fragments and when yes, then create a split.

Former Member
0 Kudos

Hi

Can you use small/large picking and then split the TO using the standard profile functionallity?

James

Former Member
0 Kudos

Hey MZ,

We have a similar situation in our organization. Do you mind sharing your experinces, options, and work around you had considered?

Will be greatly helpful.

Thanks

Tejas

former_member197616
Active Contributor
0 Kudos

if it is that situation you can create two lineitems in the order one with PCE and one with PAC with the required qty .however system will allow to create TOs with alternate UOMs.