on 10-30-2009 8:34 AM
sir,
i am new in qm module n and i m going to implement for qm module.
so pl tell how i maintain qm configuration data n calibration process of qm.
Hi,
Beside the things mentioned in Mr. Sujit's mail, pl. note that you have to maintain "Inspection Point" in task list header data and Inspection characteristics also needs to be assigned to task list operations.
Your maintenance order created should have "Release" status so that "Inspection lot" can be generated for the same.
Regards
S.M.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
It is a Huge data but Inshort I can tell you
1.Create Equipment using IE01
2.Create task list in IA01/IA05
3.Create Maintainance plan using IP01
schedule the equipment in the same with fix cycle.
4.Schedule through IP30.
Also In customization against PM order define the Inspection lot origin 14
After scheduling Inspec lot of 14 will be created
Then Do RR & DR
This is how it will be used
REgrads
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
98 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.