on 05-23-2006 12:40 PM
I want to use the extractor 0CO_PC_PCP_03 to enable me to derive cost extimates. However the standard extractor provides itemization at the very lowest component level, and not at the sub component/assembly level in a BOM.
Is there any way of controlling this with either a config change or an OSS note?
Any help would be much appreciated.
Tim
were you able to change the level of itemization in this case for 0co_pc_pcp_03
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.