debugging

[Former Member]

Hi Friends,

I m trying to debug my program.

Let us my prog name is zxy. Now in command bar i typed /h & press enter & after it whenever i press F5 for debugging my program name is changed. I wanted to know how to debug my program.

Tell me step by step procedure.

Regards,

Salil

[Former Member]

Hi,

Check this link

Debugger

http://help.sap.com/saphelp_47x200/helpdata/en/c6/617ca9e68c11d2b2ab080009b43351/content.htm

http://www.cba.nau.edu/haney-j/CIS497/Assignments/Debugging.doc

http://help.sap.com/saphelp_erp2005/helpdata/en/b3/d322540c3beb4ba53795784eebb680/frameset.htm

Mark Helfull Answers .

Regards

[Former Member]

se38 --> enter name --> shift+F5

[Former Member]

Hi Salil,

You type /h in command prompt and debug, system will take you through series of SAP standard programs and then finally to your Z program. Instead you can directly place a break point in your Z program so that you are taken there directly. To set break-point, place cursor on the code line, go to Utilities-->Breakpoints

-->Set/Delete

Thanks.

Ajay Kiran

[Former Member]

Hi Salil,

Could you please close the thread if you got the solution based on the posts?

Thanks.

Ajay Kiran