on 10-26-2009 11:02 AM
Hi, i have activated 01 insp in mat master. auto asignment is ticked, 100% insp specified. after gr, in qa32 shows the status of the insp lot as crtd. i want rel satus. for that i opend the insp lot, getting the message that specifications not yet assigned. what could be the reason. please advise. please note that i have created insp plan with qp01 for this material also.
Dear Raju
Make sure that the usage mentioned in the inspection type and used in the inspection plan are same.
Config > QM > Quality inspection > inspection lot creation > maintain inspection type
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Check the Status of Inspection PLan Created for this Material..it should be Released (General)
Best Regards,
Raghavendra K Nayak
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.