Adapter Engine - Messages in To Be Delivered status

[Former Member]

Hello,

I am using a SAP XI 3.0.

Checking the Message Monitoring, I have seen that there are a lot of messages in status To Be Delivered. I think that this status in an initial status because then the message has to be set to Delivering in a next step.

Specifically, the mentioned status is related to a Communication Channel which is configured as below:

Adapter Type: XI

Transport Protocol: HTTP 1.0

Addresing Type: URL Address

Target Host: A determined value

Service Number: A determined value

Authentication Type: Use Logon Data

User Name: A determined value

Password: A determined value

There is no module added in Module tab.

I think the problem is that messages are queued requesting any information but I do not know if there is any place to check it (in smq2 transaction, the queues are empty and this kind of channel is not shown in Communication Channel Monitoring).

Thanks in advance.

Best regards,

Gemma

Edited by: Gemma Boldu Capdevila on Oct 21, 2009 3:08 PM

[Former Member]

Faced similar problem for JDBC receiver adapter in PI 7.1.

All the messages from IS->AFW were struck without any error in status 'To Be Delivered'. This was resolved by redeploying the jdbc adapter.

Sachin

[Former Member]

Hi,

You have to clear that particular queue in message monitoring of RWB.

Check the following links:

http://help.sap.com/saphelp_nw70/helpdata/en/45/d4b62755002e97e10000000a155369/content.htm

http://help.sap.com/saphelp_nw70/helpdata/en/49/e3fb40ef74f823e10000000a155106/content.htm

Your problem should be solved now.

Regards,

Supriya.