Hours assigned to a resource are not showed in CAT2

[former_member209919]

Hi,

We have configured cproject in order to hours are entered by CAT2. When a employee assigned to a task enter in CAT2 see this task-WBS in his worklist ( this works OK), The problem we have found is hours assigned in cproject are not being retrieved in CAT2.

My question is, Is it possible hours planned for a resource in a task in cproject were showed in worklist in CAT2 when this resource enter as employee?

Thanks a lot for your help!!!

Sara

[Former Member · Accepted solution]

Check if your ECC is on EHP3 pack.

If its below that, the std Worklist doesnt support this functionality of hours from cProjects to CAT2 screen

Niranjan

[former_member209919]

Hi Niranjan,

Thanks for your help. Yes, my ECC is on EHP3. Cproject and WBS are showed in the worklist, this works fine, but hours are empty.

For your answer I understand hours can be transfer to cproject to CAT2 worklist , If this is correct I suppouse my problem can be in CAT2 settings instead of cproject settings.

Thanks,

Sara

[Former Member]

Hi

Other than Project Type, there is not setting in cProjects SPRO

you need to check CATS settings in CAC1 for with clock times and other settings and also in CAC2

Niranjan

[Former Member]

Hello SaraGil,

we have the same issue -> hours from cprojects not visible in CATS Worklist

we use EH3 and settings CAC1 & CAC2 are made, have you found a solution ?

Could you pls inform us

tx Wim

[nirajsikligar]

hi Wim,

Plese follow the below mentioned link, i t might help you resolve the isssue.

Regards,

Niraj