on 10-08-2009 1:37 PM
I registered RFC destination in tcode SMQS and excuted report RSTRFCT0 in order to create an outbound queue qRFC.
The result is that I can see the queue just created in SMQ1.
However, I can have good understanding about inbound side.
I also registered exact the queue in SMQR and expected to see the relevent inbound LUW underlying this queue. But the fact is I cannot see anything. The list in SMQ2 is empty.
Is there anything I understand in wrong way?
Any help would be appreciated. Thank you.
Yes, I have created queue in SMQR of receiving system with exact name in coordination with the parameter in report RSTRFCT0 , but after exceuting the report RSTRFCT0 in sending system, what I excepted to see in receiving queue didn't appear.
I set the queue with U status and assumed the incoming LUWs would pipe up in that queue but it didn't. I'm confused.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Brad,
Have you created queues in SMQR? Is data continuously coming into the system? SMQ2 will show LUW only if data is flowing through system.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.