Recorded results are not getting printed in Quality certicate

[Former Member]

Hi all ,

values of the Recorded results are not getting printed in Quality certicate .

can some body help me on this .

thanks ,

ksr

[Former Member · Accepted solution]

Hi,

Have you closed the Characteristcis?

Regards,

Arpit

[Former Member · Accepted solution]

Hi all

Execept the result values , every thing is coming .

i had checked all the mentioned parameters

1. using same MIC in Task list & certificate.

2.Done RR & taken UD.

3.MIC is reference MIC.

4. profile is attached to material

Do i need to make any changes for the characteristic assigned to the certificate profile

but still is there any thing else .

thanks ,

ksr

Edited by: sridhar kodi on Oct 13, 2009 12:04 PM

[Former Member · Accepted solution]

Hi,

1. You are using reference characteristics. Do you have variant config/batch determination procedure? Check for the inspection results origin in certificate profile(It can come from RR/Batch characteristics).

2. Are you using "QM_QCERT_01" form? If you are using some "Z" form, ask abaper to debug it.

3.Check required characteristics indicator in certificate profile.

[Former Member]

Hi

Is the MIC's used are same in Certificate Profile & in Task list are same.?

Have you valuated all the char?

for this lot UD must be taken & MIC must b released.

Regards

Sujit

[Former Member]

Hi,

Other than inspection results, are you getting all other details(charac descrip/UoM)?

If it is, then check results origin in certificate profile. Result origin should be RR.