cancel
Showing results for 
Search instead for 
Did you mean: 

Result recorded in inspection lot is not transfered to batch

Former Member
0 Kudos

Dear QM Expert,

1.I have created class char in CT04 transaction (Value-50%)

2.Assign this in CL02 to batch class,A

3.Assign this batch class to material

4.Then create MIC & assign this to class char .

5.Create Inspection plan with above MIC

The problem is when I go to result recording & put the result (50%) then it is showing in Batch classification after UD

but when I put result Say (40%) it is showing blank in Batch classification after UD .

Please help to sort the problem

Regards

S

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi

what is data Type you have selected?

what are the values you have maintained other than 50% in value tab of CT04?

Revert back

Sujit

Former Member
0 Kudos

Hi data type is numeric format ,the char value is 50%,but for defective i put as a 40%,but it is not showing in batch classification.

when i put 50% it shows in batch classification but when it is below spec i.e. 40% it does not show i n batch classfictn

Regards

Sanjay

Former Member
0 Kudos

Hi

Try to put multipla values or range in Ct04 & check

Regards

Sujit