on 10-05-2009 4:22 PM
Hi all ,
During inspection plan creation , QM inspection point is getting activated .
how can i de activate it .
where can i do this . what are the dependencies and the control parmeters it has .
thanks ,
ksr.
Hi
There can be several reasons why Inspection point is asked
You have maintained sample drawing procedure so Inspection point is mandatory
You may have been doing for either sample mgt.
In the Inspection plan header above Dynamic Modification rule Inspection point is maintained.
You can remove the same.
Regards
sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.