on 09-23-2009 1:44 PM
Dear all,
could you tell me something on the following issue,
i use IM34 to roll up the project plan value to investment programme.
although the message states Rollup of plan values for FX-INVST/2009 was carried out.
i cannot see the project plan value in the IM report or in IM35.
where is the problem?
could you give me some hints or suggestions?
thanks a lot.
Judy
Your observation might be precise. But can you recheck the values which you are going to be roll. I mean is there any planned values on your measures to roll up to IM position. Also please verify that values on measure with any std. plan cost reports of measures. & Do the IM34 roll up ( Please also check with radio button you are checking add / overwrite )
Pleasse confirm
With Regards
Nitin P.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please check if the "Status selection profile" considers the WBS element status.
Hope this helps you.
Best regards,
Rafael Oliveira
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Check the Note:106057.
Hope it helps...
Thanks!!!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.