on 09-14-2009 10:28 AM
Hi Folks,
We have implemented EP on NW04S SP14, AIX 5.3 & Oracle 10g. The installation consists of CI, DI, SCS & DB on four LPARS across two physical hosts as shown below:
Physical Host 1:
LPAR 1 - CI
LPAR 2 - SCS
Physical Host 2:
LPAR 3 - DI
LPAR 4 - DB
The DB and SCS are highly available and failover on each other.
We've noticed that when SCS failsover on DB, the CI & DI instance restart. I'm looking for information on parameters/settings needed to keep the server instance alive until SCS is available again.
Thanks.
Once ERS is configured, the CI / DI processes do not restart.
Edited by: SAP Portal Project on Oct 1, 2009 10:04 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Manoj,
We use HACMP for AIX.
Check these:
/thread/132860 [original link is broken] - Enque Server was restarted without restarting the J2EE engine (MSCS)
/thread/1329634 [original link is broken] - Critical shutdown was invoked. Reason is: Enque Server was restarted ...
Note 897583 - SAP WebAS Java 6.40 SP15 - List of corrections
Note 804078 - Replicated Enqueue Configuration on Windows
The behaviour of SAP WebAS Java was changed as of 6.40 SP15 as mentioned in SAP note 897583 - "Loss of enqueue table enforces system wide restart to assure system consistency (counter messure, install replicated enqueue server)".
Regards.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Last night we observed with our XI system. Are you using windows/cluster?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.