IDoc error on outbound side

[Former Member]

Hi.

I'm setting up a communication with (JMS adapter -> XI -> IDoc adapter).

No w to the problem. When we send the message with the IDoc adapter we get the following error.

Message has error status on outbd. side

We can see this message when I put my cursor over the red flag in the outbound status column in SXMB_MONI.

I do not think there's anything wrong with the adapter because we are using it to send an other IDoc and that IDoc gets processed correctly to the target system.

What can cause the error on the that I get above?

BR

Kalle

[Former Member]

Hi ,

There is an Error Information tab on the top of the page in the transaction SXMB_MONI

jude

[Former Member]

Sam as if you press Ctrl + F2?

When I use that I get no information.

//Kalle

[Former Member]

Hi,

go to details of that transaction and check the error that caused idoc in outbound status failure...

an error tab can be seen in the outbound binding pipeline entry of that transaction and check the error caiused that

Rajesh

[Former Member]

Not in SXMB_MONI?

What transaction to use?

BR

Kalle

[Former Member]

Check in SXMB_MONI only

[Former Member]

When I open the message there are no error tab.

//Kalle

[prateek]

Check sm58 or smq2 if you find the actual error.

Regards,

Prateek

[Former Member]

Found this in SM58.

Sender structure CLFMAS01_OBJEK does not exist

//Kalle

[Former Member]

Check the metadata is available for the same in IDX2 of PI

if exists with different segments then delete manually and rerun the scenario...

Rajesh

[Former Member]

Hi,

Had a problem due to Data Error.In my case Remote system was missing.Please check the data also.

Thanks,

Sudhansu

[Former Member]

We have populated the fields in the same way we do fro an other working solution. The only thing could be incorrect data but the receiver has confirmed that it is correct.

Trying the Metadata. Waiting for a new test.

//Kalle

[presheela_krishnan2]

Hi,

What do you meant by data error?

Where do we check the remote system?

Please advice i am facing the same problem.

Thanks