09-05-2009 12:36 PM
Hi Everybody,
In Silo Mgt., while creating tank dips, error message comes: ''QCI: Parameter VOLCORRFA1 not found in internal table''.
Can somebody suggest me, how to rectify this?
Thnx in advance.
Srin
09-09-2009 1:08 PM
Hi Srinivas,
Assuming you are doing this transaction for the first time:
Please check whether conversion group configuration is maintained in IS Oil D/S -> HPM -> Measurement Standards -> Define Conversion Groups and External Function Module Settings, here you may have to define the external ASTM function module settings or ASTM internal table (if any) - old method.
Assuming you are not doing this transaction for the first time:
Please check your QCI input parameters such as Material Temp, Test Temp, Obs Density, this may be out of range from your inetnal table entries. Steps to correct: correct the input parameters or make additional entries in the internal ASTM table
Hope the above helps.
Regards,
Anubhav
09-09-2009 1:08 PM
Hi Srinivas,
Assuming you are doing this transaction for the first time:
Please check whether conversion group configuration is maintained in IS Oil D/S -> HPM -> Measurement Standards -> Define Conversion Groups and External Function Module Settings, here you may have to define the external ASTM function module settings or ASTM internal table (if any) - old method.
Assuming you are not doing this transaction for the first time:
Please check your QCI input parameters such as Material Temp, Test Temp, Obs Density, this may be out of range from your inetnal table entries. Steps to correct: correct the input parameters or make additional entries in the internal ASTM table
Hope the above helps.
Regards,
Anubhav