Clarification on Rounding Profile and Rounding Val in Mat Master MRP view

Hi Expert,

Need some clarification on the above subject. What's its use? Does this affect during creation(data entry) of PO or PR? Or this only applies during MRP run where autocreation of PO or PR is done?

As during my initial test first data entry via ME21n on PO QTY automatically it is rounded upon pressing the enter button. But when I tried to edit the same, it does not round the value anymore.

Rounded value is 5

First try ---> I enter 3 - automatically it is rounded to 5

but when I edit the same and put 4 it no longers convert it to 5.

Appreciate your clarification. Thank you.


Helpful Answer