on 08-25-2009 12:47 PM
Dear Expert,
we are doing UD through QA16 that is collectively but problem is that after background UD. status of inspection lot Remain " UD ICCO SPCO" there is no STUP (i.e statistic update) but if i do Usage Decision by QA11 then its working fine.
and so as there is no statistic update inspection lot remain red. can you give me solution.
Regards
Pravin
Hi
In QA16 screen header use
(at bottom) Monitor control :3 .degree of processing for Inspec Lot.
Use same in QA32 & check
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi sujit
as we are using same as
(at bottom) Monitor control :3 .degree of processing for Inspec Lot. in qa16 and qa32 also
but no effect
what is the root causes
for second reply
setting is correct
Insp.lot origin 01
Insp. lot / UD 22
Description QMIS: Reduction of Inspection Lot Data for Vendor/Mat. Anal.
Result(General) 52
Description QMIS: Inspection Result for Vendor/Matl Analysis - General
Quant. result 53
Description QMIS: Inspection Result for Vendor/Matl Anal. - Quantitative
Regards
Pravin
Edited by: pravin dhokey on Aug 26, 2009 11:32 AM
Hi,
Check SPRO->QM->Information System->Define update for each Origin is useful or not.
Regards,
Tanuj Parikh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
103 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.