Simulation creation and display problem

[Former Member]

Hi All,

I had problems while creating a project in Simulation that is by CJV1

1) that every WBS created get only First level Hierarchy. No second or third level WBSE get created.

2) No Network or activity get created. Following error is coming

You have not selected an activity or a(n) WBS Element

Message no. CJ479

Even though proper WBSE is selected where I want a activity or network.

3) Another thing is I want Structre dispaly at simulations CJV1, 2 or 3 etc or switch over of structure display and project planning board graghical display. At present there is PPB view. I have checked possible ways to do this but failed

Your inputes in this regards are appreciated in advance.

Regards,

Rahul.

[Former Member · Accepted solution]

Hi Rahul,

Check whether Sumulation profile is maintained or not in your project. Check whether version key is Deactivated in OPUS ?

regards.

Hari

Edited by: Hari Krishna Kudaravalli on Aug 25, 2009 3:20 PM

[Former Member · Accepted solution]

Dear Hari,

I have checked that Simulation profile is created and Key also active.

Reagards,

Rahul

[Former Member · Accepted solution]

Dear Hari,

I have checked that Simulation profile is created and Key also active.

Reagards,

Rahul

[Former Member · Accepted solution]

Dear Hari Krishna,

Problem is solve, Simulation profile was not is Project profile so that problem arises.

Regards,

Rahul