Skip to Content

Archived discussions are read-only. Learn more about SAP Q&A

JDBC to RFC synch RFC call not executing.

Hi,

I am working on the synchronous JDBC to RFC without BPM. After completing design and config when I test the complete scenario the data from databse is not getting updated in R/3. And I do not see any errors in MONI. But when compared the moni logs I observed the following between the working scenario and not working scenario.

<u>Working scenario log in MONI:</u>

<SAP:Receiver>

<SAP:Party agency="" scheme="" />

<SAP:Service>ECS300</SAP:Service>

<SAP:Interface namespace="<b>http://sap.com/xi/XI/System</b>">InterfaceCollection</SAP:Interface>

- <SAP:Mapping notRequired="S">

<SAP:ObjectId>YYgNVKC9PTCW4JlMapfxZQ==</SAP:ObjectId>

<SAP:SWCV>IrmTYNPLEdqKItGjlusuXw==</SAP:SWCV>

<u>Not working log from the MONI:</u>

++++++++++++++++++++++++

<SAP:Receiver>

<SAP:Party agency="" scheme="" />

<SAP:Service>ECS300</SAP:Service>

<SAP:Interface namespace="<b>http://my_Own_namespace</b>">JDBC_Rfc_Synch_MI</SAP:Interface>

- <SAP:Mapping notRequired="M">

<SAP:ObjectId>28ZZbGggOw6UcnigDXMD7A==</SAP:ObjectId>

<SAP:SWCV>IrmTYNPLEdqKItGjlusuXw==</SAP:SWCV>

<SAP:SP>-1</SAP:SP>

</SAP:Mapping>

Could some body point me where I am doing wrong ?

Thaks

Steve.

Former Member
Former Member replied

Hi,

Check this

1) Does the sender JDBC adapter shows some processing in Adapter Monitor?

2) Does the receiver RFC adapter shows some processing in Adapter Monitor?

3) When you have created MT for sender JDBC,are you using some value in the <b>XML Namespace </b> textbox? If yes then

you have to give the same value in the <b>Document Namespace</b> of the sender JDBC Adapter. (or other alternative is to use blank in both places).

4) Check Message Monitoring in the Runtime Workbench.

Regards

Suraj

0 View this answer in context

Helpful Answer

by
Not what you were looking for? View more on this topic or Ask a question