on 08-24-2009 6:32 AM
Dear All,
I'm using status profile where Usage Decision can not be given until the results recording is done. What my requirement is after the results recording usage decision should be given but STOCK SHOULD NOT BE POSTED TO UNRESTRICTED. I want to do the stock posting using MB1B transaction where WM transactions execute with it. I created a UD code which hold stock in QI area. here even though i make the UD stock is not getting posted to Unrestricted. But when i try to use the MB1B following message occurs. "Change the inspection stock of material 1010622 in QM only". I hope my requirement is clear. Can some one advice a solution to this?
Regards,
DTD
when any inspection lot is created,then posting is not allowed by MB1B t_code. system will show u the same error.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
to avoid stock to be posted to unrestricted by sung user exit
QEVA0010 UD: Usage decision check
but it is not possible to do MB1B to remove material if QM view is activated( or 08 in activated)
there is no other way.
you have to do it through QA11n screen.
or customize the ZQA11 tcode so that your requirement can meet.
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
10 | |
5 | |
5 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.