Auto printing PO from SRM thru ECC in Extended Classic 5.0

[Former Member]

We are trying to print our PO's and sent then thru Smartforms ZNEU from SRM thru the back end(ECC). This was working OK until we installed new patches on the ECC side.

The ZNEU would print the Po and sent the EDI transfer from the back end with out manual intervention. Can some one tell me how we can set this backup to sent the PO print over to the back end to print.

Thanks,

Sam

[Former Member]

Had to make a custom change to get this to work.

[former_member183819]

Hi Sam,

Generally PO Messages will be created in SRM only in ECS.

Did you do any development for this specail request to create a message in ECC ? check it up.

br

muthu

[Former Member]

muthu, we did have to do some special changes to get the flow to push the PO over the the back end and print. we are currently uding the SRM Print PO to send the message over to the back end so the the message field is populated with the correct code to send over the order (EDI ) to the vendor.

[former_member183819]

Hi Sam

Check with tehnical resoure and take opinion from him.

br

muthu