Not able to call RFC from Web Dynpro : RFC_ERROR_SYSTEM_FAILURE

[Amey-Mogare]

Hi,

I have created a FM "Z_GENERIC_SERVICE" which is remote enabled. I have radio button for Remote Enabled and Start Immediately selected.

But while executing from Web Dynpro JAVA, I am getting following error :-

The function module "Z_GENERIC_SERVICE" cannot be used for 'remote' calls., error key: RFC_ERROR_SYSTEM_FAILURE

I am using fixed username/password JCOs and they tested & pinged successfully.

Any idea why this is happening?

Is it something that if FM is in Inactive mode and tried accessing, it gives this error?

Thanks and regards,

Amey Mogare

[Amey-Mogare]

Actually, FM was active but Function Group was inactive!

[Former Member]

hi

check whether you FM is remote enable , when you go to the SE37 -> your FM name , in the attributes tab

check whether remote enable radio button is selected , may be this is the problem .

[Amey-Mogare]

Hi Murali,

As I have mentioned in very first line of my question, this FM is remote enabled!

I have checked it twice.

Any other ideas?

Thanks and regards,

Amey Mogare

[Sharathmg]

Hello Amey,

Did activating the Function Group solve the issue?

If not, the error is raised during runtime on access of the RFC. Either RFC destinations/JCos may not be configured properly.

Test the connections under the System Administration before using it in the WD application.

Regards,

Sharath M G