IDOC Acknowledgment not received

[Former Member]

Hello

I am trying to configure application acknowledgment in sxmb_moni

I have configured aleud according to the guide but I dont see any acknowledgment on sxi_monitor

( I have set ACK_SYSTEM_FAILURE to 1 )

when I try to executre RDBSTATE I get the following message

No data relevant to audit were selected

any idea?

thx

Shai

Edited by: Shai Rosenzweig on Aug 13, 2009 12:55 PM

[former_member240483 · Accepted solution]

Hi,

If RBDSTATE is giving message No data relevant to audit were selected then IDOCs are not reached specific system from source system ( if you are giving correct inputs at selection screen of RBDSTATE)...

Check the inputs that you giving in selection screen for RBDSTATE..

Thanks

PT

[Former Member · Accepted solution]

thx PT for your answer

I chekced the EDI control record the partner number for the sender and recipent are the same

where can I change it ?

in xi reciver agreement I use as a sender service the same system

but if ill change it to XI system it will fail in sxmb_moni with the message "NO ALE FOUND.."

[Former Member · Accepted solution]

Make sure you are providing correct data in selection screen

In parameter Confirmations to system, select Partner profile created for XI system

Have you maintained ALEAUD message type as outbound parameter

Message Type should be the one for which you are sending ack

[former_member240483 · Accepted solution]

As above said..check your partner profiles in source for aleaud..

and you talking about control record of IDOC as source and target systems are same-- not clear in that area could you please give me more details...

Thanks

PT

[Former Member · Accepted solution]

when I send an idoc the sender and receving are the same in the EDIDC segement of the idoc( both are the ECC system)

if i change the sender system to pi ( by editing the business service logical system in integration directoy) then I get the error in we02 ( partner profile not found )

do I have to configure the sender system as the pi system to recieve the aleaud message?

is this a probilem in partner profile ( we20 ) ?

[Former Member]

Application ack needs to be send by application system then only it can receive to PI

i.e check in application system

HTH

Rajesh