cancel
Showing results for 
Search instead for 
Did you mean: 

Results Recording not Possible

Former Member
0 Kudos

Dear Gurus,

I have posted stock to quality using Mov.Type 563 in Transaction MB1C.Than Activated inspection type 0800 in MM02.Then in Transaction QA08,Activated check Box Activate despite inspection stock and Inspection type as 0800.Executed and saved the Transaction.system created inspection Lot.When i tried to record results against it,the error is

Characteristic results cannot be recorded for inspection lot 080000000050

Message no. QE181

Diagnosis

You cannot record any characteristic results for this inspection lot. The material master has been set up for the existing inspection type in such a way that results recording is not supported.

Procedure

Confirm defects for this inspection lot or select another inspection lot in which you can confirm the characteristic results.

What is the Pb?

Regards

Varma

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi

This is simply due to

You have not selected Check char( & Inspection with task list) for the inspection type 0800.

I hope you understood.

Regards

Sujit

Answers (2)

Answers (2)

Former Member
0 Kudos

PSV,

Go through the check points

1.Mm02 --> for inspection type 0800, check the field "insp with task list". Prior to this ensure "Assignment of task list usage Q to the inspection type0800 in Customizing"

2. Create inspection plan in qp01

3. Go to QA02, on "inspection specification" tab change the key date to present date and click on "Task list/spec." push button.

Go to "sample" tab and click on "smpl" push button.

4. If samples are calculated check the status of samples. if it is "REL" go for Results recording. If it is "CRTD" go to QPR4, release samples and go for Results recording.

regards

Venkat. V

former_member587434
Active Contributor
0 Kudos

>

> Characteristic results cannot be recorded for inspection lot 080000000050

> Message no. QE181

What is the status of insp lot?

This error comes because of the lot status as "CRTD". This status does not support to do inspection. To do inspection you need to put lot in status as "REL".

You need to assign inspection plan to lot, In QA02 assign insp plan & do sampling of lot. So system put lot status as REL & you can do RR.

Hope this helps.

Thanks!!!

Former Member
0 Kudos

How do you assign an inspection plant to an inspection lot in transaction QA02?

Former Member
0 Kudos

Hi,

In customizing for default value of inspection type(800) you have to activate the following check boxes, " check characteristics", "Inspection with task list" & "Automatic assignment"