Errror Message no. QE415, error in result recording

[Former Member]

Dear QM Gurus,

I have an inspection lot generated after making delivery for sales order(before goods issue to sales order), insp lot starts with 10. SAmple size to be inspected is seen equal to 103,680 Nos. While result recording, I am recording the Qualitative MIC as Ok. It is giving me following error:

Errror Message no. QE415

The value you entered exceeds an upper specification limit that is defined in the program.

For summarized recording of partial samples the specification limit is limited to 16,383 for the number of single values below or above the tolerance range

Note: In insp plan, I have not attached any sampling procedure.

Please sussgest how to change the limit from 16383 to unlimited.

Thanks and regards,

Vikas

[former_member186399]

Dear Vikas

You will have to maintain a sampling procudure with sample below 16,383 . For partial lot in 10 type you cannot have a sample unit more than 16,383

Regards

Gajesh

[former_member186399]

Dear Vikas

This is the limitation in SAP. Please make the MIC as Summarised recording and check with a new lot

Regards

Gajesh

[Former Member]

This Qualitative MIC is summarised MIC only.

Thanks and regards,

Vikas

[Former Member]

Please check whether you maintained any Inspection Points in the Header of the Inspection Plan.

Please remove that insp. pt.

Best Regards,

K. Raghavendra Nayak

[Former Member]

Insp point is not present in insp plan heaader.

Thanks and regards,

Vikas

[Former Member]

Check whether Single Results Recording is marked in MIC Control Indicators.

Best Regards,

K. Raghavendra Nayak

[Former Member]

Only one Qualitative MIC is present which is marked as summarised recording in control indicators.

Thanks and t Regards,

Vikas