Planned orders are not converted into process orders in ECC.

[Former Member]

Dear All,

The issue is that Planned orders with conversion tick are not publishing in ECC as manufacturing orders. We did check the relevant master data consistency between APO and ECC and it seems fine.

We have tried to send the conversion from APO to ECC,all the orders stuck in the R1P inbound queue with error - Order no. XXXX does not exist

Message no. C/006.

Based on above message and error we found SAP Note 515740 - Inconsistencies in table CIFORDMAP for this issue.

Used the transaction SE38 and created RCFORDCH report and 'Checking inconsistencies in table CIFORDMAP'

Here it shows order series stuck in queues no longer exists.

But not sure how to reconcile the inconsistency in the CIFORDMAP table.

Would appreciate your advice.

Regards,

Sajit SIngh

[Former Member · Accepted solution]

Hi Sajit singh,

1) Please run /sapapo/ccr for planned/process orders and try

2) Also check whether number range is defined in both R/3 and

APO customisation for planned/process orders.

Please confirm your findings

Regards

R. Senthil Mareeswaran.

[Former Member · Accepted solution]

Hi Senthil,

Thanks a lot for your quick reply.

I have checked the order no range in ECC & APO and found ok.

I have adopt the changes with changing 'source of supply' for planned orders and then executed CCR.

By doing this conversion for some of the orders has been moved to ECC (converted in to process orders).

But still there is a same issue for some of planned orders.

With Regards,

Sajit SIngh

[Former Member]

Hi Sajit Singh,

Could you take some sample items struck for order conversion and check

whether active PPDS & SNP PPMs available.

In some cases, conversion will be affected for want of PPMs. If it is the

case with you, try generating the PPM first for that sample item and retry

converting the orders.

Could you please check and confirm this.

Regards

R. Senthil Mareeswaran.

[Former Member]

Dear Senthil,

Thanks a lot for your response.

I have checked all the PPDS & SNP PPMs are active.

The problem is that system picking up the process order number (713014601, 713014610) but could not save the orders (may be update tables due to system inconsistency).

With Regards,

Sajit Singh

[Former Member]

In addition to the checks suggested by Senthil,

1. Check if the material master has Work Scheduling View created. WS view is a mandatory view for creation of a Prodn/Process order.

2. Check the R/3 Planned order using T.Code: MD13, if Conversion indicator for planned order is set or not. If not set, you will not be able to convert the order. You may have to verify all the master data.

Hope this Helps...

Vignesh M

[Former Member]

Hi Vignesh,

Work scheduling view is maintained for all the materials.

Conversion indicator is 'ticked' in ECC also, but displayed as planned orders only (not gettinmg converted in to Process order).

Thanks a lot,

With Regards,

Sajit SIngh

[Former Member]

For any Process Orders to be created the Order type is mandatory.( ECC )

Check whether you have maintained the Production scheduling Profile.

Check whether you had maintained Production Scheduler

Check whether you had maintained MRP Group.

Also if you are using PV and Product cost collector, check whether PCC is released.

Thanks,

nandha

[Former Member]

Dear Nandakumar,

I have checked all the mandatory fields loke Production scheduler,Production scheduling profile,MRP group etc.

All are fine and PCC is also released for the products.

with regards,

sajit singh