on 07-31-2009 5:56 AM
Hello,
We have installed GRC AC 5.3 with latest patch and configured SLD configuration. It is working fine but the standard virsa Jco destinations are not visible.
Is there any additional settings required to get that Jco destinations?
Regards,
Kumar Rayudu
Hi Kumar,
JCo destinations not showing might be happening because of following two reasons
1. AC capabilities are not deployed properly as mentioned by our friends in this message.
2. Might be an issue with SLD Data Supplier in Visual Admin(VA):
To resolve this logon to VA and select "SLD Data Supplier" under services. On right hand side bottom, you will see
tabs of "Information", "HTTP Settings" & "CIM Client Generation Settings".
Make sure entries in these tabs are correct and check for Data Transfer through SLD in these tabs. Once these tests are passed. Restart who system (not just J2ee).
If the issue still persists, redploy AC capabilities via SDM with "Deployment Configuration" is set to "Update deployed SDA/SCAs that have any version".
Hope this resolves your issue.
Best Regards,
Sirish Gullapalli.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
No Kumar. Once you install all the components of RAR on WAS, you should be able to see all the necessary JCo destiations in the JCo configuration screen. I have not seen this issue before.
Can you ask your basis people to check the installation?
Regards,
Alpesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
If RAR has been installed properly then there is no reason that you should not be able to see the JCo destinations.Did you look into the COntent Administration option of Netweaver to configure the JCos?
Were you able to see them before applying the latest patch?
Harleen
SAP GRC RIG
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.