on 07-29-2009 4:02 PM
Hi,
I am using a queue filter for prioritization. Scenario is a JDBC-XI-RFC and an EOIO. I have created the sender/receiver ID and created the queue filter for the Outbound EOIO. Ideally it should be directed to the XBTA* queue. When I test my scenario, it still goes to the XBTO* queue. I have the filter and all 21 queues activated.
I have followed the how to guide from SDN. Is there any additional configurations to be activated?
regards
Unni
Hi,
Find below link for more holp on priority configuration
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please check this link out for your help.
http://help.sap.com/saphelp_nw04/helpdata/en/04/827440c36ed562e10000000a155106/frameset.htm
Thanks,
Arijit Guha
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
double check with entries made in SXMB_ADM. Maybe the queue XBTA* is used in case the message is above a certain size and therefore msg is put into this queue. Also check your filter and prioritization entries regarding any overlaps.
Regards,
Kai
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.