Materials replication and R3PRODSTYP - SYSFAIL in inbound queues

[dmp-dmagi_cml]

Hi,

We are using SRM 7.0 and we have a problem in materials replication. In inbound queues we have the status SYSFAIL and the following error:

R3A* Error in Mapping (Details: transaction SMW01)

In SW01 the error messages are: u201CDownload inicial material: Table not supported by functionu201D and u201CCategory for material type MAT_Z001 does not existu201D

We did the initial download of DNL_CUST_PROD1 and the materialu2019s group corresponding to R3MATCLASS were replicated successfully. However 2 product subtype, corresponding to R3PRODSTYP, were not replicated.

Thus, the materials are not being replicated.

Do you have any ideas?

Thanks in advance,

Best regards,

AN

[dmp-dmagi_cml]

Hi,

Thank you for your help. The problem is resolved. The issue was with the filters.

Thank you, one more time, for your help.

[dmp-dmagi_cml]

We already did the initial download of DNL_CUST_PROD0, DNL_CUST_PROD1, MATERIAL...

The problem is that there are two material types that at this time donu2019t exist in R/3 and when we do the material download those material types are trying to be replicated...

Any help?

Thanks!

Best Regards,

AN

[Former Member]

Can you again Run DNL_CUST_PROD0 so that thsoe 2 material type replicates and then run MATERIAL

[Former Member]

Can you please try downloading the object DNL_CUST_PROD0 and then try MATERIAL