on 07-21-2009 6:01 PM
Hi,
We are using SRM 7.0 and we have a problem in materials replication. In inbound queues we have the status sysfail and the following error:
R3A* Error in Mapping (Details: transaction SMW01)
In SW01 the error messages are: u201CDownload inicial material: Table not supported by functionu201D and u201CCategory for material type MAT_Z001 does not existu201D
We did the initial download of DNL_CUST_PROD1 and the materialu2019s group corresponding to R3MATCLASS were replicated successfully. However the product subtype, corresponding to R3PRODSTYP, was not correctly replicated. Thus, the materials are not being replicated.
Do you have any ideas?
Thanks in advance,
Best regards,
AN
same issue as mine, I just delete the stuck entries in smq2 in SRM and smq1 in R/3 to proceed.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi AN,
Do you mind verifying your setup with this blog? : /people/marcin.gajewski/blog/2007/02/05/how-to-replicate-material-master-from-r3-to-srm
Also in ECC system, what are your entries in the table : CRMPRLS?
Regards,
Nikhil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi everyone,
I have the same problem. Anyone solved that?
Thanks in advance.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.