on 07-21-2009 12:20 PM
LT06 - While creating a TO after GR, a pop-up comes to choose place for inspection-sample qty. Where is the setting for this pop-up done ? can we remove it ?
Hi,
Check also WM/QM interface in spro
Logistic execution --> warehouse management --> interfaces --> quality management --> define inspection sample control.
Probably the inspection sample has the value "2 remains in GR zone"", change it in "3 putaway.
René
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Check following setting
Logistic excecution>WM>Activities-->Define Mvt type >Select 101/103 Mvt type>
check setting
Screen control :
TO Creation 1
TO Confirmation 1
TO Display 1
Regards
Sujit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.