Usage decision - characteristics relavent for usage decision

[Former Member]

Hi friends,

In usage decision screen, either all characteristics are shown or only characteristics relavent for usage decision is shown.

How do we make a charactertics as usage decision relavent, so that it is shown in usage decision screen by default.

Regards

CSN.

[Former Member]

hi

either all characteristics are shown or only characteristics relavent for usage decision is shown

Char relevent to UD are except follwing.

1.Char is skip -->you apply DMR for Char or at lot level in task list header or at char level.

2.Required char is not ticked in the Control indicator of cha.that means you have selected Optional char.

3.You have not selected task list indicator in QM view.

These are only possibilities that all char will not appear in the UD screen.

Regards

Sujit

[Former Member]

HI Sujit,

The char is not skip.

I have ticked the "required char" in the charcteristics

I have selected the task list indicator in the QM view for the subjected material.

Still its not showing all the characteristics under the "relavent for usage decision"

Any further info????

Regards

[Former Member]

Hi

What is status of inspection lot.

CRTD or REL

again go to QA02

is there any tab of Inspection specification ?

is task list attached?

Please revert back

Sujit

[Former Member]

Inspection lot status - REL.

I did infact the result recording....

Yes the task list is assigned to the lot....

Every thing looks to be ok.. but this characteristics is not shown as " relavent for usage decsion" in the usage decision screen.

only when i select "All characteristics" then it is shown.....

But question still is - how do I make a MIC as Usage decision relavent. so that when doing usage decision, the MIC is shown by default in the screen...

[Former Member]

In control indicator of MIC mark characteristic as required characteristics.

All MIC will be shown by default in the screen.

plz. revert back if issue is not solved