on 07-15-2009 10:52 PM
We have created the connector in Compliance Calibrator for MQA system
We ran the user Full Synch and Incremental Synch.
But the Sod Report doesn't show any SOD's.
SOD's are shown for the different system's the user has same Roles in
the two systems.
Is something we are missing?
Venkat,
You need to run 1) Full User Sync, 2) Full Role Sync, 3) Full Profile sync if you are using profiles, 4) Full Risk Analysis and 5) Management Reports to see SoD violations.
I did not understand meaning of this statmenet:
"SOD's are shown for the different system's the user has same Roles in the two systems."
What do you mean by this?
Regards,
Alpesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Venkat,
You have to upload and generate rules for every new connector (new system you add) to run the SOD
report on it. Once you upload the rules and generate them then only the SOD report will show up. Of course that you have to run, sync and batch risk analysis jobs as well.
Regards,
varun
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.