on 05-01-2006 6:28 PM
We are planning a refresh of SAP R/3 47 and SRM EBP 4.0. Copies of all data from our production system will be refreshed onto our test environment.
Is there a program that can be run to reset the "Destination" targets as there is with "source" using BDLS?
We can copy out certain tables and reimport, but we fear that we may be missing something. If anyone has informatoin on the process for performing a refresh, we would appreciate hearing about it.
Thanks,
BIll
Message was edited by: William Olliver
Using BDLS and clearing out some of the custom tables (allowing normal programs to rebuild data points) did the trick.
Hi Bill,
BDLS takes care of the table entries that correspond to the Logical System. This takes care of almost 80-90% of the entries.
Keep in mind however, you will need to change all the entries that correspond to an backend RFC destination or other webservers once a copy is made; as those are not updated by BDLS.
Some of these are (as it is entirely dependent on the scenarios being implemented):
DEFINE BACKEND SYSTEMS:
--IMG>SRM>...
ORGANIZATION STRUCTURE
--Use standard program RHOMATTRIBUTES_REPLACE
--Plus, Change other attributes: POrg,PGrp,Plants...
EDI/IDOC/ALE entries for partner profiles
--WE21 etc.
TWPURLSVR, TWPURLPATH, etc
--Table entries
WORKFLOW Verification Steps
--IMG>Workflow...
MIDDLEWARE PARAMETERS in R/3 and SRM.
--Table Entries
CATALOG ENTRIES
--IMG>Master Data...
Hope this helps.
-Sachin Sethi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.