on 07-13-2009 7:56 AM
Hi Guys,
I don't understand why during usage decision, system pops up the following message even though I have force the inspection completion on one particular inspection characteristic.
Valuate the non-valuated QM characteristics manually? Yes button and No button
After hits Yes button, another message appears...
Class characteristic QNNVM1 can be manually evaluated.
There are two inspection characteristics in this inspection lot, and one inspectin characteristic has been record as pass and accepted during result recording, while another inspection characteristic (which is a required characteristic on system setup) did not perform result record. Thus, during QA11, I force this required characteristic to inspection completion.
My questin is why the system gave me "Valuate the non-valuated QM characteristics manually?" message?
Thanks
YY
Plz. tell me whether sampling procedure is used for these characteristics ?
If yes then whether valuation mode is 'valuate manually ' ?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.