on 04-28-2006 8:25 PM
Hello All,
I have installed all the adapters, but when i go to Adapter monitor, only BC,XI adapter have green light, rest all are inactive (no green,yellow or red). I checked under sap.com/xi/XI/System and all the adapter are there. Tried loading the Basis Content again, but it gives error and fails.
Any ideas..
Thanks
Nainesh
Just configure one File Adapter and activate it. Then check for the same.
Thanks,
Moorthy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
you will only get a green light for a specific adapter type if you have configured and activated at least one communication channel for that specific adapter type.
So the inactive sign in your case directly after the installation is ok.
Regards
Christine
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
After importing BASIS component try to refresh the cache.
- Go to SXI_CACHE -> Adapter Engine ->Refresh the cache.
Check these-
https://websmp101.sap-ag.de/~sapidb/011000358700003163902004E/HowTo_handle_XI_30_Caches.pdf
- Go to Adapter Monitoring Guide to know more-
https://websmp103.sap-ag.de/~sapdownload/011000358700002757652005E/HowtoMintorAF.pdf
Hope this helps,
regards,
moorthy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.