cancel
Showing results for 
Search instead for 
Did you mean: 

Task list

Former Member
0 Kudos

Hi, task list, what it consist of, how to use that in qm module, any equivalent functionality available in qm? pls guide.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Task list is nothing but inspection plan, it consist of characteristics which u inspect in material.

1) What it consist of ?

Basically Task list is divided into 3 parts

i) Header level

ii) Operation level

iii) Characteristics level

T_code for task list is QP01,QP02, QP03

2) How to use that in qm module ?

To use it 'Inspect with task list' should be activated in inspection setup of material for particular inspection type.

Inspection plan should be craeted for that material plant combination. It can be also created for vendor also.

When inspection lot is craeted inspection plan is attached to thta lot and u can inspect material with inspection characteristics. Results can also be recorded for these characteristics.

3) Any equivalent functionality available in qm ?

Material specification, configuration are also equivalent to task list.

Former Member
0 Kudos

Hi, thank u. what we should we mention at header level, operation level, characterstic level. can u pls explain with one example.

Former Member
0 Kudos

At header level

Maintain usage and status

Dependeing upon the inspection type usage changed. It is maintained in QCC0 ->quality inspection -->inspection lot creation --> maintain inspection type -->Task list usage.

At operation level

For example : there are 2 operation drilling and punching

in both the cases u have different parameters to be checked.

so maintain 2 operation. Different work centers can also be maintained for each operation.

At characteristic level

In each operation there are some characteristics to be checked.

In operation 1 characteristics Dia A and Dia B can be put. Separte upper lower limits can also be maintained.

In operation 2 Characteristics like Surface Finish Test certificate can be maintained

Characteristics are of 2 types Quantitative and Qualitative type. For characteristics MIC and Inspection methods can also be attached.

U can use this link

http://help.sap.com/saphelp_45b/helpdata/en/2d/351e09448c11d189420000e829fbbd/frameset.htm

Answers (0)