on 07-01-2009 5:13 PM
Dear All,
I am facing a problem. kindly help out
When we book sales order, one particular condition type say ZA03 condition rate and condition value is set to zero. However there are condition records for the same valid on pricing date. and when we check through Pricing analysis it says ZA03 condition record found and complete.
With Regards
Madhu
Hi ,
Go to Pricing procedure configuration. TA - V/08 . Check for your condition type, if any calculation routine (under "alternative calculation type") is active than check the routine logic. Check especially if this routine is customized one.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Madhu,
Can you check "calculation type" in the customizing of condition type as well. If it is quantity based and scales are active than check if your master record has any scale based values. Also check any scale based formula in same transaction.
Also check your requirement type routine in pricing procedure configuration. Certain routines like "23" will show record only at the time of billing.
If everything is correct than please tell what kind of condition type you are using ??
Have you performed an analysis for this condition and check the access sequence?
Hase the condition recrd been marked for deletion ?
Check and then get back
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
7 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.