Seeburger/XI monitoring

[Former Member]

Hello guys...i am trying to post a file using sender adapter to VAN using AS2 adapter. not doing any design as i just need to push a file. Only doing config.

Monitoring :

1) I will not see anything in abap stack : moni : since no mapping?

2) I see sender and recv comm channel monitoring as Green : so its good.

3) I am not seeing anything in message monitoring ? is it expected or not?

4) Seburger monitor i am not seeing anything in that ?

Could someone share some insight into my queries.

Best regards

[former_member200962 · Accepted solution]

even if there are no IR objects, still you would have created channels....so check what the log for your Channels show in RWB ---> Component Monitoring ---> Adapter Engine ---> CC Monitoring..

Regards,

Abhishek.

[Former Member]

Hi

On Channel Component Monitoring you can see the Status for the Adapters, and the Log for Them if they has a problem also you can see if Seeburguer Adapter is fine.

Regards.

[Former Member]

What about message monitoring?

[Former Member]

Well before the message pass to Message Monitor you can check if the channel is correct.

After this step you can view your message.

[Former Member]

Well i see channels as green : sender and receiver.

But i dont see any message in message monitor.what culd be the reason?

Thank you.

[Former Member]

Can you verify the status of the Channel on Adapter Log (Channel Independent). RWB ---> Component Monitoring ---> Adapter Engine -> CC Monitoring..>

By other way try this. Stop your channel --> Refresh --> start. again.

Please check the result on the Tab Cluster Node and Processing Details for Cluster Node Server.