Smartform Probelm

[Former Member]

Hi Experts,

I am create the smartform its working fine excecute through driver program.

But the problem while this smartform is attached to output type through the NACE its not showing any output.

Pls help me

Thanks in Advance

purnaneelu

<MOVED BY MODERATOR TO THE CORRECT FORUM>

Edited by: Alvaro Tejada Galindo on Jul 14, 2009 12:01 PM

[Former Member]

helpful

[Former Member]

Hi,

First check the entry in the NACE i.e. TNAPR table for the output message type.

check whether the driver program and form name both are given properly or not.

Now by putting the break point in the program, check whether it is populated with any data or not first.

Regards,

Santhosh.

[former_member555112]

Hi,

What is the exact error?

Is the customising in NACE proper? Is your driver program given in NACE.

Put a breakpoint in your driver program and check.

Activate update debugging so that it goes to your driver program and then check.

Regards,

Ankur Parab

[Former Member]

Thanks for your replay

I am update my driver program in nace.

I am put the break-point in my driver program but its not all calling my program after click the printview popup is disappears only its remains in the first screen

Pls suggest me

Thanks in Advance

purnaneelu

[former_member555112]

Hi,

It will not go to the breakpoint directly.

Before pressing print preview activate debugging.

In debugging activate system debugging and update debugging.

And then press print preview.

It should then go to your driver program if your customising is correct.

Can you show the customising entries which your have maintained in NACE?

Regards,

Ankur Parab