Same Output through BPM

[Former Member]

Hi,

I have used the Switch condition in BPM to determine the receiver from the IDOC.

1) I am getting the same output(same content) for both the receivers though i have given the filter condition in the BPM.

2) In SXMB_MONI i get 3 messages, the first message says "Message Branched" and the other 2 are successful messages.

Any tips on where i could have gone wrong?

Thanks,

Tirumal

[Former Member]

hi,

Figured out the problem.

1. I have 2 receiver determinations so the message is being sent to both the receivers.

2. I think as a result of the above message being branched i am seeing a status of "Message Branched" in the SXMB_MONI.

Thanks,

Tirumal

[moorthy]

Tirumal,

This problem may be because of the namespace in the Incoming Message. Check the XPATH in the COndition Editor. Or redo once again and activate.

Still Switch is not working properly , then you may need to do dummy Interfaces and Mapping to check this.

Hope this helps,

regards,

Moorthy