on 06-24-2009 11:41 AM
Hi,
I think this is the most common error that one can face and have seen quite a few threads in the forum. Still, i couldn't resolve my problem.
I am getting the following error when i tried to connect to SAP using SAP JCO connector with load balancing.
(102) RFC_ERROR_COMMUNICATION: Connect to message server failed
Connect_PM MSHOST=sapserver, R3NAME=D11, GROUP=Group1
LOCATION CPIC (TCP/IP) on local host
ERROR partner not reached (host sapserver, service sapmsD11)
TIME Wed Jun 24 16:05:49 2009
I added the service sapmsD11 in the services file of my client as well as in R/3 server.
I got the above error when i tried to connect using load balancing. Without load balancing, i was able to connect to R/3 server successfully. Can any one tell how to figure out the message server host name ?
Can the application server host name and message server host name be same ?
PS: I am able to ping my R/3 server from my client.
Thanks,
Prasad.
Hi,
Check that you have configured properly using the below document. And check the message server of R/3 is configured properly in the SLD.
Function module to get the message server host name and port in R/3.
SLDAG_GET_MESSAGE_SERVER_INFO
See this thread also..
Regards,
Charan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.