on 06-19-2009 7:23 AM
Hi Friends,
Error encountered in Smartform:
Message no. SSFCOMPOSER181
Diagnosis
You tried to switch to the next table column, but no other column exists. The current column is 10. The line type %LTYPE1 contains only 10 columns.
System Response
The system issues an error message.
Procedure
Check whether the current line type is the desired line type and whether you defined a switch to a new table line.
%LTYPE1 contains only one cell consisting Material Description & Code .Apart from that nothin is there in line.
Please help.
Regards,
Abhishek.
Hi,
some where in yourSmartform you has put in your output conditions go to new cell (and maybe skipp some cells). This goes beyond the number of cells defined. Look for the line %LTYPE1 and search and count the cells you are using. SSFCOMPOSER faults are hard to find, but i think this one is not that difficult.
success Gr., Frank
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Abhishek,
The error which is being thrown is surely for the line type, the way it is divided.
Make sure that -
1] The cells are divided in such a way that they all together make up the width of the table/template.
2] check the number of columns again.
Hope it helps.
Thanks,
rashmi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
check what is going else for JEX billingtype documents.
if that does not work out you can try to locate where it is going wrong.
how you do that: Disable a part of your form with conditions.
then if you have done it so far you didn't get that error meesage. Then shrink the part you have disabled until it goed worng again. Then it is going wrong in the last part you have enabled. It is a lot of work but debugging in smartform is not as easy as in sapscript.
success., Gr., Frank
Hi Abhishek,
In the smartform --> In the table check the line type how many cells does it contains.
or else check the line type and assign the line type for the table.
Regards,
Sravanthi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
9 | |
9 | |
9 | |
6 | |
6 | |
5 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.